show voice port - Tecnológico de Costa Rica
show voice port - Tecnológico de Costa Rica show voice port - Tecnológico de Costa Rica
Voice Over IP for the Cisco 3600 Series Commands CHAPTER This chapter documents new commands. All other commands used with this feature are documented in the Cisco IOS Release 11.3 command reference documents. The following new commands are used to configure and monitor Voice over IP: • acc-qos • answer-address • codec • comfort-noise • connection • cptone • description • destination-pattern • dial-control-mib • dial-peer voice • dial-type • echo-cancel coverage • echo-cancel enable • expect-factor • fax-rate • icpif • impedance • input gain • ip precedence • ip udp checksum • music-threshold • non-linear • num-exp • operation Voice Over IP for the Cisco 3600 Series Commands 4-1 4
4-2 • output attenuation • port • prefix • req-qos • ring frequency • ring number • session-protocol • session-target • show call active voice • show call history voice • show dial-peer voice • show dialplan incall number • show dialplan number • show num-exp • show voice port • shutdown (dial-peer configuration) • shutdown (voice-port configuration) • signal • snmp enable peer-trap poor-qov • snmp-server enable traps • snmp trap link-status • timeouts initial • timeouts interdigit • timing clear-wait • timing delay-duration • timing delay-start • timing dial-pulse min-delay • timing digit • timing interdigit • timing pulse • timing pulse-interdigit • timing wink-duration • timing wink-wait • type • vad • voice-port Voice over IP for the Cisco 3600 Series Software Configuration Guide
- Page 149 and 150: Configuring E&M Interfaces 28 Voice
- Page 151 and 152: List of Terms List of Terms This se
- Page 153 and 154: Cisco Connection Online Cisco Conne
- Page 155 and 156: CHAPTER Configuring Voice over IP f
- Page 157 and 158: Prerequisites Tasks Prerequisites T
- Page 159 and 160: Configuration Tasks To configure Vo
- Page 161 and 162: Configure RSVP for Voice Enable RSV
- Page 163 and 164: You should configure Multilink PPP
- Page 165 and 166: Enable RTP Header Compression on a
- Page 167 and 168: Frame Relay for Voice over IP Confi
- Page 169 and 170: Table 2-1 Sample Number Expansion T
- Page 171 and 172: Figure 2-5 Outgoing Calls from the
- Page 173 and 174: Configure POTS Peers To configure t
- Page 175 and 176: Configure VoIP Peers Verify Tips Co
- Page 177 and 178: • Call progress tone using the cp
- Page 179 and 180: Fine-Tune FXO and FXS Voice Ports T
- Page 181 and 182: Validation Tips Step Command Purpos
- Page 183 and 184: Step Command Purpose Fine-Tune E&M
- Page 185 and 186: Configure CODEC and VAD for Dial Pe
- Page 187 and 188: Step 8 Click the Up button until th
- Page 189 and 190: Limit TCP Transactions Limit TCP Tr
- Page 191 and 192: Establish Queueing and Congestion S
- Page 193 and 194: Establish Queueing and Congestion S
- Page 195 and 196: Establish Queueing and Congestion S
- Page 197 and 198: Modify the System Buffer Size To di
- Page 199: Performance Management Examples The
- Page 203 and 204: Command Syntax Conventions Command
- Page 205 and 206: acc-qos 4-6 Example The following e
- Page 207 and 208: answer-address 4-8 Example The foll
- Page 209 and 210: comfort-noise comfort-noise 4-10 To
- Page 211 and 212: cptone cptone 4-12 To configure a v
- Page 213 and 214: description description To include
- Page 215 and 216: destination-pattern 4-16 Related Co
- Page 217 and 218: dial-peer voice dial-peer voice 4-1
- Page 219 and 220: echo-cancel coverage echo-cancel co
- Page 221 and 222: echo-cancel enable echo-cancel enab
- Page 223 and 224: fax-rate fax-rate 4-24 To establish
- Page 225 and 226: icpif icpif 4-26 To specify the Cal
- Page 227 and 228: input gain input gain To configure
- Page 229 and 230: ip udp checksum ip udp checksum 4-3
- Page 231 and 232: non-linear non-linear 4-32 To enabl
- Page 233 and 234: operation operation To select a spe
- Page 235 and 236: port port 4-36 To associate a dial
- Page 237 and 238: eq-qos req-qos 4-38 To specify the
- Page 239 and 240: ing number ring number To specify t
- Page 241 and 242: session target session target 4-42
- Page 243 and 244: show call active voice show call ac
- Page 245 and 246: show call active voice 4-46 Table 4
- Page 247 and 248: show call history voice show call h
- Page 249 and 250: show call history voice 4-50 Table
Voice Over IP for the<br />
Cisco 3600 Series Commands<br />
CHAPTER<br />
This chapter documents new commands. All other commands used with this feature are documented<br />
in the Cisco IOS Release 11.3 command reference documents.<br />
The following new commands are used to configure and monitor Voice over IP:<br />
• acc-qos<br />
• answer-address<br />
• co<strong>de</strong>c<br />
• comfort-noise<br />
• connection<br />
• cptone<br />
• <strong>de</strong>scription<br />
• <strong>de</strong>stination-pattern<br />
• dial-control-mib<br />
• dial-peer <strong>voice</strong><br />
• dial-type<br />
• echo-cancel coverage<br />
• echo-cancel enable<br />
• expect-factor<br />
• fax-rate<br />
• icpif<br />
• impedance<br />
• input gain<br />
• ip prece<strong>de</strong>nce<br />
• ip udp checksum<br />
• music-threshold<br />
• non-linear<br />
• num-exp<br />
• operation<br />
Voice Over IP for the Cisco 3600 Series Commands 4-1<br />
4