show voice port - Tecnológico de Costa Rica

Step Command Purpose
Fine-Tuning E&M Voice Ports
11 timing digit milliseconds If the voice-port dial type is DTMF, configure the
DTMF digit signal duration. The range of the DTMF
digit signal duration is from 50 to 100 milliseconds.
The default is 100.
12 timing inter-digit milliseconds If the voice-port dial type is DTMF, configure the
DTMF inter-digit signal duration. The range of the
DTMF inter-digit signal duration is from 50 to 500
milliseconds. The default is 100.
13 timing pulse-digit milliseconds If the voice-port dial type is pulse, configure the
pulse digit signal duration. The range of the pulse
digit signal duration is from10 to 20 milliseconds.
The default is 20.
14 timing pulse-inter-digit milliseconds If the voice-port dial type is pulse, configure the
pulse inter-digit signal duration. The range of the
pulse inter-digit signal duration is from 100 to 1000
milliseconds. The default is 500.
15 timing wink-duration milliseconds Configure the timing wink-duration value. This
value sets the wink signal duration for a wink-start
signal. This value applies only if the signal
command is set to “wink-start.” The range is from
100 to 400 milliseconds and the default is 200.
16 timing wink-wait milliseconds Configure the timing wink-wait value. This value
sets the wink wait duration for a wink-start signal.
This value applies only if the signal command is set
to “wink-start.” The range is from 100 to 5000
milliseconds and the default is 200.
17 timing clear-wait milliseconds Configure the timing clear-wait value. This value
sets the amount of time between the inactive seizure
signal and the call being cleared. The range is from
100 to 2000 milliseconds and the default is 400.
18 timing delay-duration milliseconds Configure the timing delay-duration value. This
value sets the delay signal duration for delay dial
signaling. This value applies only if the signal
command is set to “delay-dial.” The range is from
100 to 5000 milliseonds and the default is 140.
19 timing delay-start milliseconds Configure the timing delay-start value. This value
sets the delay interval between the generation of the
delay-start signal from incoming detection seizure.
This value applies only if the signal command is set
to “delay-dial.” The range is from 100 to 290
milliseconds and the default is 150.
20 timing percentbreak percent Configure the timing percent-break value. This value
sets the percentage of the break period for a dialing
pulse. The default is 50 percent.
Note After you change any voice-port command, it is a good idea to cycle the port by using the
shutdown and no shutdown commands.
Configuring Voice Ports VC-113