G-13.mft parallel - NRI
G-13.mft parallel - NRI
G-13.mft parallel - NRI
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
G-<strong>13.mft</strong> totalizer MAINTENANCE AND SERVICE<br />
6 Maintenance and service<br />
In this chapter you will find out how to<br />
• clean the G-<strong>13.mft</strong> and<br />
• remedy the cause of a malfunction.<br />
Cleaning totalizer<br />
The totalizer must only be wiped clean from time to time with a damp cloth<br />
(lukewarm water with a small amount of washing-up liquid). Beyond that, no<br />
further maintenance work is required.<br />
National Rejectors, Inc. GmbH, Buxtehude<br />
Under no circumstances may the cloth be so wet that fluid<br />
runs into the device. Otherwise the PCB will be damaged.<br />
Do not use any solvents or scouring agents that will attack the<br />
plastic material of the device.<br />
1 Pull the machine’s mains plug.<br />
2 Carefully open the flight deck 1 on the left-hand side and hold it open<br />
(Fig. 6).<br />
3 Use a cloth to wipe off the coin runway inside the totalizer.<br />
4 Close the flight deck again.<br />
5 Reconnect the machine to the mains supply.<br />
Fig. 6: Open the flight deck of the totalizer<br />
1<br />
55