G-13.mft parallel - NRI

FUNCTION AND OPERATION (TIMER) G-13.mft totalizer
Data-manage the residual credit
If the credit cannot be precisely converted into time, the accruing residual
credit can be data-managed in a number of ways:
• Reset residual credit immediately
Residual credit is reset after the time has elapsed
• Retain residual credit
Residual credit can be used for another vend or another customer
• Retain residual credit for two minutes
Changing the residual credit data-management
Extend the elapsing time by coin insertion
Reset line
If the customer is not supposed to be able to extend an already elapsing time
by the insertion of further coins, this restriction can be set using the
configuration software. The timer will not accept coins again until the time
has elapsed.
The activation of the reset line will interrupt the elapsing of the time. The price
line remains activated.
Activate service using start button (on-request mode)
If the time for a service is not supposed to elapse immediately after the price
has been reached, the customer can activate the vending operation using
the start button so that the timer transmits the signal to the machine only
upon individual request.
For the on-request mode, the combined reset/request signal line must be
connected to a start button (see section "Interfaces (pin assignment and
connection diagrams)" in Chap. 8 "Technical data").
Activate/deactivate on-request mode
26 National Rejectors, Inc. GmbH, Buxtehude