G-13.mft parallel - NRI

G-13.mft totalizer SAFETY INSTRUCTIONS
Protecting yourself and equipment
National Rejectors, Inc. GmbH, Buxtehude
The coin validator may only be connected by a qualified
electrician.
Only use the coin validator according to proper use. Under no
circumstances can the manufacturer be held liable for any
damage or loss resulting from improper use of the device.
The coin validator PCB is fitted with components that can be
damaged by electrostatic discharge. Please observe the
handling instructions for components exposed to the risk of
electrostatic discharge.
Pull out the machine’s mains plug before you install, clean or
remove the coin validator.
Select the correct voltage for the coin validator (see label).
Ensure the correct potential equalization in the machine.
Never pull the connecting cable of the coin validator from the
machine when a voltage is applied.
Contact NRI if you wish to alter the construction of the device
to a greater extent than that described in these instructions.
Keep water and other liquids away from the coin validator.
If the device is no longer required, please dispose of it
correctly.
We reserve the right to make technical modifications to the
device which are not covered by these instructions.
11