AionDS Messages and Codes Guide

AionDS runtime errors
.........................................................................................................................................................................................................˝..........................................
1018
Invalid argument passed to the TIME function
The format of the argument for a KDL TIME function is not a valid format.
If the user chooses to abort, the consultation is terminated immediately. If
the user does not choose to abort, AionDS continues executing the KDL
property using the value UNKNOWN for the TIME function.
.........................................................................................................................................................................................................˝..........................................
1019
Unable to complete the agenda; it references an unprocessed parameter
A parameter referenced in the agenda cannot be processed, so AionDS is
unable to complete the agenda.
.........................................................................................................................................................................................................˝..........................................
1115
Left Margin is greater than Right Margin
There is no room for text on the line because the specified left margin is to
the right of the right margin. Check the use of &LM, &RM, &LI, and
&RI. In reports, also check the Left Margin and Right Margin properties.
.........................................................................................................................................................................................................˝..........................................
1116
Message or block too long; truncated
The TSL text is longer than the maximum size of 65,512 characters. This
limit applies to messages and to blocks of text (marked with the &BLK
command) within reports. The text is shown up to the point at which it was
truncated.
In a report, this error might be due to a &BLK+ command that does not
have a corresponding &BLK- command.
The size of a message is calculated by multiplying the number of lines times
the width of the window in which the message is shown. Note that the size
of a message cannot be computed before runtime because of indirect
substitution.
AionDS Runtime Errors 1-55