AionDS Messages and Codes Guide

MAESLOG messages
The following list shows the type of information that each log message,
within the specified log message range, contains:
Log Message Numbers Type of Information
1000 - 1999 Task Management
2000 - 2999 VTAM Management
3000 - 3999 Control Block Dump
4000 - 4999 Startup and Termination
5000 - 5999 Partner Management
11000 - 11999 Task Management
12000 - 12999 VTAM Management
13000 - 13999 Control Block Dump
14000 - 14999 Startup and Termination
15000 - 15999 Partner Management
The MAESLOG messages are listed below in ascending numerical order.
.........................................................................................................................................................................................................˝..........................................
1000
MAESBFPL
The transaction driver passed data to the inference engine in the form of a
Fixed Parameter List (FPL). This does not mean that the transaction driver
sent any data using FPL. Instead, the normal method of passing data to the
attached subtask is in the FPL format. The transaction driver sends data to
the inference engine prior to the starting of a new consultation. In the FPL
format is the command line which is passed to the inference engine. This can
be used to verify that the correct knowledge base is being started.
.........................................................................................................................................................................................................˝..........................................
1001
MAESETXR
This log message is issued when a subtask ends normally.
MAESLOG Messages 6-3