CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Second level configuration mode commands<br />
Put “no” in front of this command to turn off the<br />
DHCP server on this interface.<br />
[dhcp_relay ]<br />
This allows you to use a separate DHCP server on<br />
your network to serve DHCP addresses, with the<br />
Vclass acting as a DHCP agent.<br />
Example<br />
WG(config-if)#interface 0 10.12.12.7<br />
255.255.255.0 \<br />
-mtu 1500 -100_half_duplex no<br />
dhcp_server<br />
or<br />
WG(config-if)#interface 0 10.12.12.7/24 -mtu<br />
1500 \<br />
-100_half_duplex no dhcp_server<br />
or<br />
WG(config-if)#interface 0 10.12.12.7/24 -mtu<br />
1500 \<br />
-100_half_duplex dhcp_relay<br />
10.0.0.253<br />
private command (configure interface level, V10<br />
only)<br />
WG#config<br />
WG(config)#interface<br />
WG(config-if)#private <br />
[no] dhcp_server -clients NUMBER [lease_time<br />
NUMBER]<br />
Effect<br />
Use this command to configure DHCP server<br />
options assigned to a <strong>WatchGuard</strong> V10 appliance's<br />
Private (0) interface.<br />
<strong>WatchGuard</strong> Command Line Interface <strong>Guide</strong> 85