CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Second level configuration mode commands<br />
Effect<br />
Displays the current network address settings for<br />
each of the main security appliance data<br />
interfaces–0 (private), 1 (public) or 2 (DMZ, where<br />
applicable.)<br />
Arguments<br />
None.<br />
Example<br />
WG(config-if)# show<br />
The results appear as shown in this example:<br />
interface 0: ip = 10.10.13.101<br />
net<br />
mask = 255.255.0.0<br />
status = UP<br />
mac<br />
address = 00:01:21:10<br />
:01:e5<br />
interface 1: ip = 16.10.203.121<br />
net<br />
mask = 255.255.255.0<br />
status = DOWN<br />
mac<br />
address = 00:01:21:10<br />
:01:e6<br />
interface 2: ip = 10.20.0.1<br />
net<br />
mask = 255.255.255.0<br />
status = DOWN<br />
mac<br />
address = 00:01:21:10<br />
:01:e7<br />
interface 0 command (configure interface level)<br />
WG#config<br />
WG(config)#interface<br />
WG(config-if)#interface 0 [ [-mtu<br />
num]<br />
[-100_full_duplex | -<br />
100_half_duplex|<br />
<strong>WatchGuard</strong> Command Line Interface <strong>Guide</strong> 83
Change language