CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CHAPTER 3: Configuration Mode Commands<br />
HA2 interface of the master and backup<br />
appliances–if needed.<br />
<br />
This command will, depending on your use,<br />
activate or deactivate the HA system.<br />
polling_interval <br />
This optional command establishes the HA polling<br />
interval. The default value is “1 second”, but you<br />
can increase it to “15” if you choose.<br />
id <br />
This optional command notes the VRRP group ID<br />
for this HA pairing, if one has been assigned to it.<br />
The number should be between 1 and 255.<br />
Example<br />
WG(config-ha)# monitor {pub} poll<br />
5<br />
Apply high availability configuration changes<br />
WG#config<br />
WG(config)#high_availability <br />
WG(config-ha)#exit<br />
Effect<br />
Initiates the process of saving and applying any<br />
just-completed HA interface configurations. You<br />
will be asked to confirm the committing of these<br />
changes, at which time you can press Y to do so.<br />
Arguments<br />
None<br />
Example<br />
WG(config-ha)#exit<br />
Commit (Y/N)?y<br />
…<br />
HA IP address is set to 12.10.1.2,<br />
please wait for it to take effect…<br />
WG(config-ha)#<br />
76 <strong>WatchGuard</strong> Vclass 5.1