CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CHAPTER 3: Configuration Mode Commands<br />
history command<br />
WG#config<br />
WG(config)#history<br />
Effect<br />
Shows the last 20 commands exercised at this level<br />
of <strong>CLI</strong>. Note, too, that you can apply it at any level<br />
of the <strong>CLI</strong>.<br />
For example, you may apply the “history”<br />
command after extensive policy creation, and see a<br />
series of 20 commands, starting with “64” and<br />
ending with “83”–the most recent command<br />
being listed as 83.<br />
Arguments<br />
None<br />
Example<br />
WG(config)#history<br />
Results<br />
Executed Commands:<br />
0 ike<br />
1 address<br />
2 address "pubs" -host 10.10.99.1<br />
3 show address pubs<br />
4 dos<br />
5 denial<br />
WG(config)#<br />
Second level configuration mode commands<br />
The following sections detail the second-level configuration<br />
commands, has been divided into “task” or “topical”<br />
collections, which include the following:<br />
• “Level 2 certificate configuration commands” on<br />
page 67<br />
66 <strong>WatchGuard</strong> Vclass 5.1