CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Top-level configuration mode commands<br />
Effect<br />
Runs a trace for the specified object.<br />
Arguments<br />
None in this mode.<br />
tenant command<br />
WG#config<br />
WG(config)#tenant<br />
Effect<br />
Enters the tenant configuration mode, at which<br />
point you can record a new tenant entry for either a<br />
VLAN or user-domain tenant.<br />
Arguments<br />
None in this level.<br />
See Also<br />
See “Level 2 tenant configuration commands” on<br />
page 119 for more information about the next level<br />
of tenant commands.<br />
tunnel_switch command<br />
WG#config<br />
WG(config)#tunnel_switch <br />
Effect<br />
Enables (or disables) the tunnel switching<br />
capability of this <strong>WatchGuard</strong> appliance, according<br />
to the specific argument. (Must be done before<br />
applying specific tunnel-switching security<br />
policies.)<br />
Arguments<br />
<br />
The default state is “disable”.<br />
Example<br />
WG(config)#tunnel_switch enable<br />
<strong>WatchGuard</strong> Command Line Interface <strong>Guide</strong> 65