CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CHAPTER 3: Configuration Mode Commands<br />
-firewall pass -ipsec SJ_NY_IPSec<br />
<br />
WG(config)#policy SJ_LA_VPN \<br />
-mss_adjustment_per_policy \<br />
limit_to 1400<br />
WG(config)#policy SJ_NY_VPN \<br />
-icmp_error_handling_per_policy all<br />
WG(config)#policy SJ_NY_VPN -position 5<br />
<br />
The previous example shows a relocation of policy<br />
SJ_NY_VPN to the fifth position (row) in the policy<br />
table.<br />
NOTE<br />
You can combine a range of actions (“-vlan”, -“ipsec”, “nat”,<br />
“-schedule”, etc.) in a single policy, as needed. For<br />
more information on policy action combinations, especially<br />
to determine what will and what won’t work, see the User<br />
<strong>Guide</strong>.<br />
qos command<br />
WG#config<br />
WG(config)#qos<br />
Effect<br />
Enters the Quality of Service (QoS) configuration<br />
mode, at which point you can enter QoS actionspecific<br />
task commands and their arguments.<br />
Arguments<br />
None in this mode.<br />
See Also<br />
For more information about “QoS” mode<br />
commands, see “Level 2 Quality of Service (QoS)<br />
configuration commands” on page 100.<br />
60 <strong>WatchGuard</strong> Vclass 5.1
Change language