CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CHAPTER 2: Administration Mode Commands<br />
automatically logged out of the appliance, but after<br />
a few minutes (and a considerable display of status<br />
messages), the main login prompt will appear. You<br />
can log in again at this time.<br />
Arguments<br />
None.<br />
restore default command<br />
WG#admin<br />
WG(admin)#restore_default<br />
Effect<br />
Reinitializes this appliance and restores the<br />
original “factory default” configuration. Once this<br />
process is complete, you can log in again, then start<br />
over with appliance installation, configuration and<br />
policy creation, either by manual entry or<br />
importing of a profile from another appliance.<br />
Arguments<br />
None.<br />
Results<br />
After applying this command, the <strong>CLI</strong> will<br />
immediately record a series of “restoring” status<br />
messages, along with “please wait…” messages.<br />
When the restoration is complete, the main login<br />
prompt will appear.<br />
You can now log into the appliance with the user<br />
name of “admin” and the password of “admin” to<br />
begin reconfiguration of this appliance.<br />
shutdown command<br />
WG#admin<br />
WG(admin)#shutdown<br />
Effect<br />
38 <strong>WatchGuard</strong> Vclass 5.1
Change language