CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies CLI Guide - WatchGuard Technologies
CHAPTER 4: Debug Mode Commands NOTE This feature is not supported in software versions earlier than 5.0. Example WG#debug WG(debug)# vinstall 10.10.0.98 ftpadmin ftppass /upload/downgrade/encrypted.tgz 142 WatchGuard Vclass 5.1
CHAPTER 5 Other Commands No command Rename command This chapter describes commands that do not belong to one of the three main command modes (Administration, Configuration, and Debug). The no command is used before another command or argument to turn off or disable the specified feature. The rename command is used to rename objects. WatchGuard Command Line Interface Guide 143
- Page 105 and 106: Arguments Second level configurati
- Page 107 and 108: Second level configuration mode com
- Page 109 and 110: Second level configuration mode com
- Page 111 and 112: Second level configuration mode com
- Page 113 and 114: Second level configuration mode com
- Page 115 and 116: Second level configuration mode com
- Page 117 and 118: Second level configuration mode com
- Page 119 and 120: Second level configuration mode com
- Page 121 and 122: Second level configuration mode com
- Page 123 and 124: Second level configuration mode com
- Page 125 and 126: Second level configuration mode com
- Page 127 and 128: Second level configuration mode com
- Page 129 and 130: Second level configuration mode com
- Page 131 and 132: Second level configuration mode com
- Page 133 and 134: Second level configuration mode com
- Page 135 and 136: Second level configuration mode com
- Page 137 and 138: Level 3 configuration mode commands
- Page 139 and 140: Level 3 configuration mode commands
- Page 141 and 142: CHAPTER 4 Debug Mode Commands All W
- Page 143 and 144: arp command Debugging/troubleshooti
- Page 145 and 146: Debugging/troubleshooting commands
- Page 147 and 148: - images/rs_sublogo.gif Debugging/t
- Page 149 and 150: pppoe_config command Debugging/trou
- Page 151 and 152: Debugging/troubleshooting commands
- Page 153 and 154: set_dos_if command Debugging/troubl
- Page 155: Debugging/troubleshooting commands
- Page 159 and 160: Show address command Display curren
- Page 161 and 162: Show all_routes command WG#show all
- Page 163 and 164: Effect Displays any DNS configurati
- Page 165 and 166: Show command component, action or p
- Page 167 and 168: Show command Effect Displays whethe
- Page 169 and 170: Show command Arguments This argume
- Page 171 and 172: Show command Arguments This argume
- Page 173 and 174: Show command Effect Displays the ba
- Page 175 and 176: Index A abbreviations 8 abort syste
- Page 177 and 178: administration mode disable 108 CLI
- Page 179 and 180: log configuration, level 3 commands
- Page 181: X xml export debugging information
CHAPTER 5 Other Commands<br />
No command<br />
Rename command<br />
This chapter describes commands that do not belong<br />
to one of the three main command modes (Administration,<br />
Configuration, and Debug).<br />
The no command is used before another command or<br />
argument to turn off or disable the specified feature.<br />
The rename command is used to rename objects.<br />
<strong>WatchGuard</strong> Command Line Interface <strong>Guide</strong> 143