CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
set_dos_if command<br />
Debugging/troubleshooting commands<br />
WG#debug<br />
WG(debug)set_dos_if<br />
[show | set | set_default | -h | -? ], where<br />
show Show the current settings.<br />
set xyzv Set DOS protection on interfaces.<br />
x,y,z,v must be 0 or 1. x is for interface 0,<br />
y for interface 1, z for interface 2,<br />
and v for interface 3.<br />
set_default Restore the setting to the factory default value<br />
Effect<br />
This sets denial of service (DOS) protection on<br />
individual interfaces. The default settings are<br />
0000000f.<br />
Example<br />
WG#debug<br />
WG(debug)set_dos_if set 0011<br />
slink command<br />
WG#debug<br />
WG(debug)# slink [ [-s] ] [show]<br />
-s : save configuration only<br />
Port: eth0, eth1, eth2, eth3<br />
Mode:<br />
auto = Auto negotiate<br />
1000A = 1000BaseFX, AutoNegotiation enabled<br />
1000H = 1000BaseFX, AutoNegotiation disabled<br />
100F = 100BaseT, Full-duplex mode<br />
100H = 100BaseT, Half-duplex mode<br />
10F = 10BaseT, Full-duplex mode<br />
10H = 10BaseT, Half-duplex mode<br />
show: current setting<br />
Effect<br />
This command sets the physical speed of a specific<br />
accelerated data interface.<br />
Arguments<br />
etho, eth1, eth2, eth3<br />
Indicates the interface to be changed.<br />
mode<br />
auto = Auto negotiate<br />
<strong>WatchGuard</strong> Command Line Interface <strong>Guide</strong> 139