CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
pppoe_config command<br />
Debugging/troubleshooting commands<br />
pppoe_config [show | set num | set_default]<br />
show Show current settings.<br />
set num Set PPPoE parameters.<br />
-i is for echo interval (1-1200 Sec).<br />
-f is for echo failure (1-60).<br />
-r is for re-auth period (0-7200 Min).<br />
-t is for re-auth interval (0-120 Min).<br />
num is an integer.<br />
set_default Restore factory default value.<br />
Effect<br />
This command allows you to set PPPoE echo (keepalive)<br />
and re-authorization times and limits.<br />
Arguments<br />
-i allows you to set the echo (keep-alive) interval,<br />
from 1—1200 seconds.<br />
-f allows you to set the threshold for echo (keepalive)<br />
failure, from 1—60 seconds.<br />
-r allows you to set the re-authorization period,<br />
from 0—7200 minutes.<br />
-t alows you to set the re-autorization interval,<br />
from 0—120minutes.<br />
set_default allows you to set the default values<br />
for PPPoE echo and re-authorization.<br />
Example<br />
WG(debug)#pppoe_config set -1 300 -f 5\<br />
-r 1800 -t 60<br />
radius_ping command<br />
WG#debug<br />
WG(debug)#radius_ping \<br />
[-pap |-sid ] \<br />
[-p ] [-r ] \<br />
[-s ] [-t ] \<br />
[-u ] <br />
Effect<br />
Use this command to test the connections between<br />
this <strong>WatchGuard</strong> appliance and a RADIUS server.<br />
<strong>WatchGuard</strong> Command Line Interface <strong>Guide</strong> 135