CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CHAPTER 4: Debug Mode Commands<br />
Arguments<br />
enable<br />
Enables HTTP debugging.<br />
disable<br />
Disables HTTP debugging.<br />
logon_html [standard | alternate ]<br />
Standard allows you to use the deault HTML logon<br />
debugging page. Alternate allows you to use the<br />
alternate HTML logon page.<br />
Example<br />
WG#debug<br />
WG(debug)#config_http enable logon_html<br />
alternate<br />
conn_idle_timeout command<br />
WG#debug<br />
WG#debug conn_idle_timeout [show | set |<br />
set_default | -h | -? ], where<br />
show Displays the current settings<br />
set Set the connection idle timeout (in<br />
seconds, 1-86400)<br />
Effect<br />
This allows you to set the connection idle timeout<br />
between the Vclass appliance and the Management<br />
Station. The maximum time is 86,400 seconds (one<br />
day). The default is 180 seconds (3 minutes).<br />
Example<br />
WG#debug conn_idle_timeout 600<br />
WG#debug conn_idle_timeout set_default<br />
ha_instant_sync command<br />
WG#debug<br />
WG#debug ha_instant_sync [show | enable | disable |<br />
set_default | -h | -? ], where<br />
show Displays the current settings<br />
enable Enable instant state sync<br />
disable Disable instant state sync<br />
130 <strong>WatchGuard</strong> Vclass 5.1