CLI Guide - WatchGuard Technologies

CHAPTER 4: Debug Mode Commands
Debugging information is not synced between HA appliances.
Command For more information
arp See “arp command” on page 129.
clear_logs See “clear_logs” on page 129.
config_http See “config_http command” on page 129.
conn_idle_timeout See “conn_idle_timeout command” on page 130.
ha_instant_sync See “ha_instant_sync command” on page 130.
hwdiag See “hwdiag command” on page 131.
ifconfig See “ifconfig command” on page 131.
importscreen See “importscreen command” on page 132.
kernel_debug See “kernel_debug command” on page 133.
netstat See “netstat command” on page 134.
ping See “ping command” on page 134.
pppoe_config See “pppoe_config command” on page 135.
radius_ping See “radius_ping command” on page 135.
rcinfo See “rcinfo command” on page 137.
reboot See “reboot command” on page 137.
rs_kdiag See “rs_kdiag command” on page 138.
set_dos_if See “set_dos_if command” on page 139.
slink See “slink command” on page 139.
tcpdump See “tcpdump command” on page 140.
traceroute See “traceroute command” on page 140.
verbose_trace See “verbose_trace command” on page 141.
vinstall See “vinstall command” on page 141.
show See “Show command” on page 144.
history See “history command” on page 14.
exit See “exit command” on page 14.
top See “top command” on page 15.
128 WatchGuard Vclass 5.1