CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Level 3 configuration mode commands<br />
Effect<br />
Configures a new static route utilized by traffic<br />
passing through this <strong>WatchGuard</strong> appliance.<br />
Arguments<br />
<br />
Use this argument to record the IP address of the<br />
destination subnet.<br />
<br />
Use this argument to record the number of bits in<br />
the subnet mask, or the destination subnet mask.<br />
<br />
Use this argument to record the IP address of the<br />
next gateway to the destination subnet.<br />
interface <br />
This argument specifies which interface in this<br />
security appliance is used for outgoing traffic using<br />
this route.<br />
delete<br />
Type this argument before typing the arguments<br />
for a route, to deactivate that particular route.<br />
Example<br />
WG(config-route)#static 0.0.0.0/0 \<br />
105.10.74.122 pub<br />
Configure dynamic routing<br />
WG#config<br />
WG(config)#system<br />
WG(config-sys)#route<br />
WG(config-route)# [no] dynamic<br />
[import|restart]<br />
Effect<br />
Configures dynamic routing in this <strong>WatchGuard</strong><br />
Firebox Vclass security appliance.<br />
<strong>WatchGuard</strong> Command Line Interface <strong>Guide</strong> 123
Change language