CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Second level configuration mode commands<br />
Effect<br />
Enables this appliance to be managed by means of<br />
the <strong>WatchGuard</strong> Centralized Policy Manager<br />
(CPM). You can also use this command to disable<br />
CPM as needed. If enabling CPM access, be sure to<br />
enter the CPM-access password immediately<br />
following the “enable” argument.<br />
Arguments<br />
enable<br />
Enter this argument to activate <strong>WatchGuard</strong> CPM<br />
access to this <strong>WatchGuard</strong> appliance.<br />
<br />
Enter the text of the CPM access password after<br />
“enable”.<br />
disable<br />
Enter this argument if you have already<br />
established CPM access and want to disable the<br />
connection.<br />
Example<br />
WG(config)#cpm enable<br />
cpm_admit_1<br />
fwuser command (configure system level)<br />
WG#config<br />
WG(config)#system <br />
WG(config-sys)#fwuser -t<br />
[seconds|minutes]<br />
Effect<br />
Allows you to change the value for a firewall user<br />
connection idle timeout. The system default is two<br />
hours, and the default increment is "seconds".<br />
Argument<br />
-t [seconds|minutes]<br />
<strong>WatchGuard</strong> Command Line Interface <strong>Guide</strong> 109
Change language