CLI Guide - WatchGuard Technologies

CHAPTER 3: Configuration Mode Commands
used by this account, and should be between 6 and
8 characters in length.
[-full_name ]
This argument notes the full name of the user, up to
15 characters in length.
[-group_profile “profile_name”]
This argument specifies which user group profile
affects this user account. The default choice is
“default setting”.
[-pw_expiry ]
This argument sets the number of days until the
user’s password expires. The default is 90 days.
[-account_expiry ]
This argument sets the number of days until this
account expires. The default lifetime is 180 days.
[-concurrent_logins ]
This argument limits the number of concurrent
connections this account user can establish. The
default is 1.
Example
WG(config-ras)#user enable jdoe \
-password jdsecret -full "John Doe" \
-group admGroup -pw_expiry 60 -account
60 \
-concurrent 1
Results
To review and confirm your entries, type this
command:
WG(config-ras)#show user jdoe
The results are displayed, similar to this example:
User Profile|
Name = jdoe
Full Name = "John Doe"
Enabled
Description = ""
User Group Profile = admGroup
104 WatchGuard Vclass 5.1