CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Arguments<br />
<br />
Second level configuration mode commands<br />
This argument records the IP address assigned to<br />
this interface.<br />
<br />
This argument records the number of bits in the<br />
subnet mask (for example, “/16” is equivalent to<br />
the address 255.255.0.0), or the actual subnet mask<br />
address.<br />
-mtu num<br />
This allows you to set the size of the Maximum<br />
Transmission Unit (MTU). The default is 1500<br />
bytes.<br />
[-100_full_duplex | -100_half_duplex|<br />
-10_full_duplex|-10_half_duplex | -<br />
auto]] |<br />
This setting allows you to specify the speed at<br />
which the interface will operate.<br />
Example<br />
WG(config-if)#interface 2 10.12.12.9<br />
255.255.255.0 \<br />
-mtu 1500 -10_full_duplex<br />
or<br />
WG(config-if)#interface 2 10.12.12.9/24 -mtu<br />
1500 \<br />
-10_full_duplex<br />
interface 3 (DMZ2) command (configure interface<br />
level, V60 and V80 only)<br />
WG#config<br />
WG(config)#interface<br />
WG(config-if)#interface 3 <br />
[-mtu num]<br />
[-100_full_duplex | -<br />
100_half_duplex|<br />
<strong>WatchGuard</strong> Command Line Interface <strong>Guide</strong> 91