CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
CLI Guide - WatchGuard Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CHAPTER 3: Configuration Mode Commands<br />
Example<br />
WG(config-if)#interface 1 10.10.12.8\<br />
255.255.0.0 -mtu 1500\<br />
-10_full_duplex<br />
or<br />
WG(config-if)#interface 1 10.10.12.8/16<br />
-mtu 1500 -10_full_duplex <br />
Example (PPPoE)<br />
WG(config-if)#interface 1 pppoe\<br />
-user joeuser -password joepass\<br />
-always_on 60<br />
Example (DHCP)<br />
WG(config-if)#interface 1 dhcp dhcpsrvr<br />
Example (Backup Connection)<br />
WG(config-if)#interface 1 10.10.12.8<br />
255.255.0.0 -mtu auto\<br />
-backup ip 10.10.24.16 mask 255.255.0.0\<br />
gateway 10.100.99.1 tracking -add<br />
124.12.15.16<br />
interface 2 (DMZ) command (configure interface<br />
level)<br />
WG#config<br />
WG(config)#interface<br />
WG(config-if)#interface 2 <br />
[-mtu num]<br />
[-100_full_duplex | -<br />
100_half_duplex|<br />
-10_full_duplex|-<br />
10_half_duplex | -auto]<br />
Effect<br />
Use this command to configure the network<br />
identity of a <strong>WatchGuard</strong> appliance's interface 2<br />
(DMZ), where applicable.<br />
90 <strong>WatchGuard</strong> Vclass 5.1