Untitled - Zippy

More documents

Recommendations

Info

Page 27 of 92 IEC 60950-1 / EN 60950-1 Clause Requirement – Test Result – Remark Verdict 4.3.6 Direct plug-in equipment Not direct plug-in type. N Dimensions (mm) of mains plug for direct plug-in : N Torque and pull test of mains plug for direct plug-in; torque (Nm); pull (N) ................................: 4.3.7 Heating elements in earthed equipment No heating elements. N 4.3.8 Batteries No batteries. N 4.3.9 Oil and grease Insulation in intended use not considered to be exposed to oil or grease. 4.3.10 Dust, powders, liquids and gases The equipment in intended use not considered to be exposed to dust, powders, liquids and gases. 4.3.11 Containers for liquids or gases No container for liquids or gases provided. 4.3.12 Flammable liquids.................................................: No flammable liquids provided. N Quantity of liquid (l)...............................................: N Flash point (°C).....................................................: N 4.3.13 Radiation; type of radiation ..................................: See below. P 4.3.13.1 General No risk due to radiation. P 4.3.13.2 Ionizing radiation N Measured radiation (pA/kg) .................................: ⎯ Measured high-voltage (kV) ................................: ⎯ Measured focus voltage (kV) ...............................: ⎯ CRT markings .....................................................: ⎯ 4.3.13.3 Effect of ultraviolet (UV) radiation on materials N Part, property, retention after test, flammability classification ........................................................: 4.3.13.4 Human exposure to ultraviolet (UV) radiation ......: N 4.3.13.5 Laser (including LEDs) No coherent radiation present. Emission of indicator LEDs far below the limits of Class 1 LED. Laser class ...........................................................: Ditto. ⎯ 4.3.13.6 Other types ..........................................................: Not used. N 4.4 Protection against hazardous moving parts N TRF No.:IECEN60950_1B TRF originator: SGS Fimko N N N N N P
Page 28 of 92 IEC 60950-1 / EN 60950-1 Clause Requirement – Test Result – Remark Verdict 4.4.1 General DC fans in module have diameters smaller than 5cm. Therefore no fan guard required. 4.4.2 Protection in operator access areas N 4.4.3 Protection in restricted access locations N 4.4.4 Protection in service access areas N 4.5 Thermal requirements P 4.5.1 Maximum temperatures See appended table 4.5.1. P Normal load condition per Annex L.......................: Maximum normal load according to the installation instructions. 4.5.2 Resistance to abnormal heat Phenolic bobbin materials used in transformers T1 and T2 that are acceptable without test. 4.6 Openings in enclosures EUT is for building-in. Compliance shall be evaluated for the final system. 4.6.1 Top and side openings N Dimensions (mm) ................................................: ⎯ 4.6.2 Bottoms of fire enclosures N Construction of the bottom ...................................: ⎯ 4.6.3 Doors or covers in fire enclosures N 4.6.4 Openings in transportable equipment N 4.6.5 Adhesives for constructional purposes N Conditioning temperature (°C)/time (weeks) ........: ⎯ 4.7 Resistance to fire P 4.7.1 Reducing the risk of ignition and spread of flame See below. P Method 1, selection and application of components wiring and materials Method 2, application of all of simulated fault condition tests Materials with the required flammability classes are used. This method is not used. N 4.7.2 Conditions for a fire enclosure See below. N TRF No.:IECEN60950_1B TRF originator: SGS Fimko N P N N P
Page 3 and 4: Particulars: test item vs. test req
Page 5 and 6: M1W4-5B40P3w w=V, H M1W4-5600P3w w=
Page 7 and 8: Copy of marking plate(s): Page 6 of
Page 9 and 10: Page 8 of 92 TRF No.:IECEN60950_1B
Page 11 and 12: Page 10 of 92 TRF No.:IECEN60950_1B
Page 13 and 14: Page 12 of 92 IEC 60950-1 / EN 6095
Page 27: Page 26 of 92 IEC 60950-1 / EN 6095
Page 49 and 50: Page 48 of 92 1.5.1 TABLE: list of
Page 51 and 52: Varistors (VZ2, VZ3, VZ4) (optional
Page 53 and 54: Power Module for: 1. M1W4-K40P3w, M
Page 55 and 56: Page 54 of 92 F1 -- 90 1644 18.32 1
Page 57 and 58: Page 56 of 92 F1 -- 90 2804 31.31 3
Page 59 and 60: Location Voltage (V) Note(s): Page
Page 61 and 62: Page 60 of 92 U5 pin 4 to pin 1 172
Page 63 and 64: Test voltage (airflow direction) Pa
Page 65 and 66: Page 64 of 92 C2 body 68.5 100 L2 c
Page 67 and 68: Page 66 of 92 Inlet pin 59.0 46.7 7
Page 69 and 70: Page 68 of 92 4.6.1, 4.6.2 Table: e
Page 71 and 72: 16. U6 pin 1 to 2 Page 70 of 92 s-c
Page 73 and 74: Page 72 of 92 48. Fan Stall 240 8mi
Page 75 and 76: Page 74 of 92 Thickness 0.8mm Elect
Page 77 and 78: Page 76 of 92 National Differences
Page 79 and 80:
Page 78 of 92 National Differences
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93:
show all

Untitled - Zippy

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?