Untitled - Zippy

More documents

Recommendations

Info

Page 11 of 92 IEC 60950-1 / EN 60950-1 Clause Requirement – Test Result – Remark Verdict 1 GENERAL P 1.5 Components P 1.5.1 General See below. P Comply with IEC 60950 or relevant component standard Components, which were found to affect safety aspects, comply with the requirements of this standard or within the aspects of the relevant IEC component standards. See appended table 1.5.1. 1.5.2 Evaluation and testing of components Components, which are certified by IEC and/or national standards, are used correctly within their ratings. Components not covered by IEC standards are tested under the conditions present in the equipment. 1.5.3 Thermal controls No thermal controls provided. N 1.5.4 Transformers Transformers used are suitable for their intended application and comply with relevant requirements of the standard and particularly with Annex C. 1.5.5 Interconnecting cables Interconnection output cables to other devices are carrying hazardous energy level higher than 240VA. Therefore compliance shall be evaluated for the final system. 1.5.6 Capacitors in primary circuits ...............................: Between lines: X1 or X2 capacitors accordingly to IEC 60384-14:1993 with 21 days damp heat test are used. 1.5.7 Double insulation or reinforced insulation bridged by components Between line and earth: Y1 or Y2 capacitors accordingly to IEC60384-14:1993 are used. See below. N 1.5.7.1 General N 1.5.7.2 Bridging capacitors No bridging capacitor used. N 1.5.7.3 Bridging resistors No bridging resistor used. N 1.5.7.4 Accessible parts Compliance shall be evaluated for the final system. TRF No.:IECEN60950_1B TRF originator: SGS Fimko P P P N P N
Page 12 of 92 IEC 60950-1 / EN 60950-1 Clause Requirement – Test Result – Remark Verdict 1.5.8 Components in equipment for IT power systems Y1 or Y2 sub-class capacitors according to IEC 60384-14:1993 provided between phase and primary ground are rated 250 V. 1.6 Power interface P 1.6.1 AC power distribution systems TN power distribution system and IT power system only for Norway. 1.6.2 Input current Highest load according to 1.2.2.1 for this equipment is the operation of the equipment at maximum specified DC load at max. power conditions. See appended table 1.6.2. 1.6.3 Voltage limit of hand-held equipment The equipment is for buildingin. 1.6.4 Neutral conductor The neutral is not identified in the equipment. Basic insulation for rated voltage between earthed parts and primary phases. 1.7 Marking and instructions P 1.7.1 Power rating Label is placed on top of metal chassis. For details see below. Rated voltage(s) or voltage range(s) (V) .............: 100-240V P Symbol for nature of supply, for d.c. only .............: AC mains supply N Rated frequency or rated frequency range (Hz) ..: 47-63 Hz P Rated current (mA or A) ......................................: 1. 40-20 Manufacturer’s name or trademark or identification mark .....................................................................: 2. 30-15 3. 20-10 4. 10-5 TRF No.:IECEN60950_1B TRF originator: SGS Fimko P P P N P P P
Page 3 and 4: Particulars: test item vs. test req
Page 5 and 6: M1W4-5B40P3w w=V, H M1W4-5600P3w w=
Page 7 and 8: Copy of marking plate(s): Page 6 of
Page 9 and 10: Page 8 of 92 TRF No.:IECEN60950_1B
Page 11: Page 10 of 92 TRF No.:IECEN60950_1B
Page 15 and 16: Page 14 of 92 IEC 60950-1 / EN 6095
Page 49 and 50: Page 48 of 92 1.5.1 TABLE: list of
Page 51 and 52: Varistors (VZ2, VZ3, VZ4) (optional
Page 53 and 54: Power Module for: 1. M1W4-K40P3w, M
Page 55 and 56: Page 54 of 92 F1 -- 90 1644 18.32 1
Page 57 and 58: Page 56 of 92 F1 -- 90 2804 31.31 3
Page 59 and 60: Location Voltage (V) Note(s): Page
Page 61 and 62: Page 60 of 92 U5 pin 4 to pin 1 172
Page 63 and 64:
Test voltage (airflow direction) Pa
Page 65 and 66:
Page 64 of 92 C2 body 68.5 100 L2 c
Page 67 and 68:
Page 66 of 92 Inlet pin 59.0 46.7 7
Page 69 and 70:
Page 68 of 92 4.6.1, 4.6.2 Table: e
Page 71 and 72:
16. U6 pin 1 to 2 Page 70 of 92 s-c
Page 73 and 74:
Page 72 of 92 48. Fan Stall 240 8mi
Page 75 and 76:
Page 74 of 92 Thickness 0.8mm Elect
Page 77 and 78:
Page 76 of 92 National Differences
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93:
show all

Untitled - Zippy

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?