cover page for test report - Zippy

More documents

Recommendations

Info

Issue Date: 2010-01-29 Page 8 of 69 Report Reference # E143756-A26-UL-2 IEC 60950-1:2005 Clause Requirement + Test Result - Remark Verdict 1.6 Power interface Pass 1.6.1 AC power distribution systems Pass 1.6.2 Input current This equipment is the operation with the max. specified DC-load. Results see appended table. 1.6.3 Voltage limit of hand-held equipment N/A 1.6.4 Neutral conductor Neutral is insulated from earth with basic insulation. TRF No. IECEN60950_1C Underwriters Laboratories Inc. Pass Pass
Issue Date: 2010-01-29 Page 9 of 69 Report Reference # E143756-A26-UL-2 IEC 60950-1:2005 Clause Requirement + Test Result - Remark Verdict 1.7 Marking and instructions Pass 1.7.1 Power rating Pass Rated voltage(s) or voltage range(s) (V).............. : See "SPECIFIC TECHNICAL CRITERIA" for detail. Symbol for nature of supply, for d.c. only............. : N/A Rated frequency or rated frequency range (Hz)... : See "SPECIFIC TECHNICAL CRITERIA" for detail. Rated current (mA or A)..................................... : See "SPECIFIC TECHNICAL CRITERIA" for detail. Manufacturer's name or trademark or identification mark ................................................................. : TRF No. IECEN60950_1C Underwriters Laboratories Inc. See "SPECIFIC TECHNICAL CRITERIA" for detail. Model identification or type reference.................. : See "SPECIFIC TECHNICAL CRITERIA" for detail. Symbol for Class II equipment only ..................... : N/A Other markings and symbols .............................. : The additional marking does not give rise to misunderstandings. 1.7.2 Safety instructions and marking Installation instruction with directions to maintain the requirements of IEC 60950 during the installation into the end system. Included are directions regarding the maximum ambient temperature and electrical rating of the equipment. 1.7.2.1 General Pass 1.7.2.2 Disconnect devices N/A 1.7.2.3 Overcurrent protective device N/A 1.7.2.4 IT Power distribution systems N/A 1.7.2.5 Operator access with a tool N/A 1.7.2.6 Ozone N/A 1.7.3 Short duty cycles N/A 1.7.4 Supply voltage adjustment ................................. : N/A Method and means of adjustment; reference to installation instructions ....................................... : 1.7.5 Power outlets on the equipment ......................... : N/A 1.7.6 Fuse identification (marking, special fusing characteristics, cross-reference)......................... : Fuse marking on PCB near fuse or provided in service Pass Pass Pass Pass Pass Pass Pass N/A Pass
Page 1 and 2: Issue Date: 2010-01-29 Page 1 of 2
Page 9: Issue Date: 2010-01-29 Page 7 of 69
Page 61 and 62:
Issue Date: 2010-01-29 Page 59 of 6
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99:
show all

cover page for test report - Zippy

Create successful ePaper yourself

Delete template?

Save as template?