9 Fusing Copy 02/11 - Franciscan Glass

FUTURE FORMS DRAPING CYLIDERS
2” DRAPING CYLINDER
Catalog #MCS081 2” tall x 1 1/4” at top x 2” mouth.
4.5” DRAPING CYLINDER
Catalog #MCS200 4 1/2” tall x 2 ” at top x 3” mouth.
MINI CANDLE CUP 4 pc. SET
Catalog #MCUPSET
1- 1” tall x 1 1/2” at top x 2 3/8” mouth.
1- 1 1/4” tall x 1 7/8” at top x 3 1/8” mouth.
1- 1 5/8” tall x 1 1/2” at top x 2 1/4” mouth.
1- 2” tall x 2 1/4” at top x 3 3/8” mouth.
FUTURE FORMS INTERWEAVE MOLDS
INTERWEAVE MOLDS
Catalog #M5301 5 7/8 ” x 5 3/8” x 3/4” deep
with 4 weaving crevices.
Catalog #M5302 9 1/8” x 8 5/8”” x 3/4” deep
with 6 weaving crevices.
Catalog #M5301 11 1/2” sq. x 3/4” deeop
with 8 weaving crevices.
3” DRAPING CYLINDER
Catalog #MCS080 3” tall x 2” at top x 3” mouth.
7” DRAPING CYLINDER
Catalog #MCS100 7” tall x 2 1/2” at top x 3 1/4” mouth.
INSTRUCTIONS FOR USE OF INTERWEAVE MOLDS
1- Cut strips of glass and lay across the humps on the mold.
2- Slump the glass strips
3- Line up wave strips so that when placed next to each other one
wave is up and one wave is down creating a hole as you look
through the edge. Pieces may be stacked edge to edge for tight
weave or with separation for loose weave.
4- Cut new strips of glass just wide enough to slide through the hole
that was created in step 3. When fired this will give the over and
under appearance of a woven piece.
10-08 9-19