English - Meijer Special Equipment

More documents

Recommendations

Info

A trademark of Meijer Special Equipment 4.2. Explanation of type plate The type plate is the plate that is located on the upper side of each telescopic fork. The type plate is mounted on the left as well as on the right fork. Both left and right must be seen from the positions of the fork-lift truck driver. The type plate contains important information about the technical specifications of the telescopic fork. Figure 4.2 shows an example of a type plate. The letters in the left plate can be found in Table 4.1 that represents the description and the measuring unit. The right plate is an example of how the type plate can be filled in. Figure 4.2 Type plate of a telescopic fork Letter Description Measuring unit A Indication of type B Production year C Serial number (L = left / R = right) D Dead weight Kg E Centre of gravity Mm F Capacity retracted Kg G Capacity extended Kg H Load centre retracted Mm I Load centre extended Mm J Maximum operating pressure MPa (1 MPa = 10 bar) Table 4.1 Description of the specifications on a type plate of a telescopic fork 6 © MEIJER SPECIAL EQUIPMENT 2005
4.3. Explanation of indication type A trademark of Meijer Special Equipment Often A at Figure 4.1 contains the type of the telescopic fork. From the type code again various information can derived. Table 4.2 gives the description of the various sections of the type code. Here is an example: RE4-35-1350-1000 Section of Description Measuring indication type unit RE Fork type (in this case telescopic fork with separate flow divider) 4 Number of cylinders per set of telescopic forks 35 Total capacity of a set of telescopic forks / LC 600mm x 100 kg 1100 Retracted fork length mm 0750 Stroke (length difference between retracted and extended fork) mm Table 4.2 Various sections of the type code and their description 4.4. Capacity The type plate, which is mounted at the upper side of the telescopic fork, shows among other things the maximum carrying capacity per telescopic fork. This data is also engraved on the side of the telescopic fork. With the following load diagram the capacity per telescopic fork or per couple of telescopic forks can be defined for each load distance. The correction factors are shown vertically and the load distances are shown horizontally counted in mm from the front side of the back of the fork. On the following page an example of the operation is given. correction factor 1,1 1 0,9 0,8 0,7 0,6 0,5 0,4 0,3 0,2 0,1 0 600 800 1000 1200 1400 1600 1800 2000 2200 Load centre (mm) Figure 4.3 Correction factors for the maximum capacity at a given load centre © MEIJER SPECIAL EQUIPMENT 2005 7
Page 1: A trademark of Meijer Special Equip
Page 4 and 5: A trademark of Meijer Special Equip
Page 40: A trademark of Meijer Special Equip

English - Meijer Special Equipment

Create successful ePaper yourself

Delete template?

Save as template?