English - Meijer Special Equipment

More documents

Recommendations

Info

A trademark of Meijer Special Equipment 6. Instructions for use Telescopic forks offer the possibility to load and unload a lorry from one side, to stack goods at warehouses double-deep, to pick up two pallets at a time, and they may be used as extension forks when operating with pallets of various dimensions. The telescopic forks are easy to mount and to demount. The telescopic forks must be tuned to the fork-lift truck for the purpose that they are intended for. The final capacity must be defined by an authorised fork-lift truck dealer. On the type plate of the fork-lift truck the capacity must be adapted to the new combination of fork-lift truck and telescopic forks. It is advisable that the fork-lift truck driver is professionally trained in the use of telescopic forks. ! ! ! Attention!: The contact of the telescopic forks with the ground, during driving and during pick-up of a load, must be avoided as far as possible. This prevents wear at the bottom of the outer forks. To prevent this wear wear-resistant pads can be welded to the underside of the outer forks. Attention!: When moving in reverse take care that the telescopic forks do not drag over the ground. This can result in damage to outer fork as well as to piston rods. Attention!: Telescopic forks of the type REE are extension forks. This type of telescopic forks is not intended to be extended and retracted when loaded. Retract or extend the telescopic forks to the required length before picking up a load. 10 © MEIJER SPECIAL EQUIPMENT 2005
7. Mounting instructions A trademark of Meijer Special Equipment In this chapter first of all several prescriptions are listed that must be observed during service work on the telescopic forks, irrespective of the type. In 7.2 the telescopic forks with a separate flow divider are dealt with. 7.3 tells about what can be done to reduce wear at the bottom of the telescopic forks. 7.1. Prescriptions There are several prescriptions that must be observed during mounting operations, inspection or maintenance of the telescopic forks. During all service work on the telescopic forks, the forklift truck should be switched off and the ignition key must be removed. When performing maintenance the hydraulic system of the fork-lift truck must have no pressure. Position the telescopic forks on the convenient ergonomic height to prevent backaches. Wear safe working clothes, shoes and safety goggles. When disconnecting the telescopic forks from the fork carrier the connection couplings of the telescopic forks must be unplugged to protect the hydraulic system from dirt that might get inside. Nothing can be welded to the telescopic forks without written consent of the manufacturer. If something is welded to the telescopic forks without written consent the guaranty on the telescopic forks terminates. © MEIJER SPECIAL EQUIPMENT 2005 11
Page 1: A trademark of Meijer Special Equip
Page 4 and 5: A trademark of Meijer Special Equip
Page 40: A trademark of Meijer Special Equip

English - Meijer Special Equipment

Create successful ePaper yourself

Delete template?

Save as template?