English - Meijer Special Equipment
English - Meijer Special Equipment
English - Meijer Special Equipment
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
5. Safety<br />
A trademark of <strong>Meijer</strong> <strong>Special</strong> <strong>Equipment</strong><br />
Safety starts with the fork-lift truck driver. That is why we advise that the driver of the fork-lift truck<br />
possesses a recognized diploma of a fork-lift truck driver.<br />
Furthermore it is important to observe the following safety instructions:<br />
1. Do not load the telescopic forks above the values defined by the manufacturer, concerning lifting<br />
capacity and load centre.<br />
2. Pull the load in if it is possible. ATTENTION, telescopic forks of the type REE are extension forks,<br />
never pull them in with a load on.<br />
3. Retract the telescopic forks during driving if there is no load on them.<br />
4. Always drive with the telescopic forks in the lowest possible position.<br />
5. Never drag the telescopic forks over the ground when driving.<br />
6. Never allow riding on the telescopic forks or load.<br />
7. Telescopic forks with defects may not be used until they are expertly repaired or replaced.<br />
8. Before you start performing service work on the telescopic forks you must make sure that the fork-<br />
lift truck is switched off and that there is no more pressure in the hydraulic system (remove the<br />
ignition key).<br />
9. The load should always be carried by the two telescopic forks as proportionally as possible.<br />
10. Always keep the exterior of the outer forks free from grease and oil.<br />
All abovementioned points must be read and understood by the fork-lift driver.<br />
!<br />
!<br />
!<br />
Warning:<br />
Never exceed the maximum carrying capacity of the fork-lift truck,<br />
irrespective of the carrying capacity of the telescopic forks.<br />
Warning:<br />
Never walk under the telescopic forks.<br />
Warning:<br />
Applicable only to telescopic forks with a high<br />
palletstop (type Y2 or Y3), that with a retracted<br />
fork is at a distance of 50mm or less from the<br />
back of the fork (from palletstop front to the front<br />
side of the back of the fork).<br />
When retracting avoid squeezing limbs or goods<br />
between the back of the fork and the palletstop.<br />
This may result in serious injury or damage of<br />
goods!<br />
© MEIJER SPECIAL EQUIPMENT 2005 9