Intel XENIX 286 Programmers Guide (86) - Tenox.tc

Programming Commands XENIX Programming
admin (continued)
-t[ name ]
The name of a file from which descriptive text for the SCCS file is to be taken. If
the -t option is used and admin is creating a new sees file {the -n and/or -i
options are also used), the descriptive text file name must also be supplied. In the
case of existing SCCS files, a -t option without a file name causes removal of
descriptive text (if any) currently in the sees file, and a -t option with a file
name causes text {if any) in the named file to replace the descriptive text (if any)
currently in the sees file.
-fflag[ flag-val ]
This option specifies a flag, and possibly a value for the flag, to be placed in the
sees file. Several f options may be supplied on a single admin command line.
The allowable flag and flag-val combinations are
B-12
b Allows use of the -b option on a get command to create branch deltas.
cceiZ The highest release {or "ceiling"), a nu mber less than or equal to 9999, that
may be retrieved by a get command for editing. The default value for an
unspecified c flag is 9999.
ffloor
The lowest release {or "floor"), a number greater than 0 but less than 9999,
that may be retrieved by a get command for editing. The default value for
an unspecified f flag is 1.
dSID The default delta nu mber {SID, or SCCS ident ification) to be used by a get
command.
Causes the "No id keywords {ge6)" message issued by get or delta to be
treated as a fatal error. In the absence of this flag, the message is only a
warning. The message is issued if no SCCS identification keywords {see get
later in this appendix) are found in the text retrieved or stored in the sees
file.
j Allows concurrent get commands for editing on the same SID of an sees
file. This allows multiple concurrent updates to the same version of the
sees file.
llist A list of releases to which deltas can no longer be made. (A get -e against
one of these "locked" releases fails.) A list is one or more list items
separated by commas. A list item is either a release number or the letter
"a" {to indicate all releases for the file).