Prisma Plus PH System - Schneider Electric

DD384404
DD384405
DD384406
DD383399
Distribution
Catalogue numbers
To satisfy safety clearances, the assembly points on adjacent
bars must be staggered as shown above.
401F_E22315.indd
DD383367
DD383400
Lateral flat busbars
up to 3200 A
Busbars 10 mm thick
Horizontal busbars connection
Connection with a horizontal busbars, 10 mm thick.
In this case, use the bottom support ref. NSYAS500, NSYAS800 or NSYAS800L.
Designation Horizontal Vert. Cat. no.
Busbars Busbars
Connection vert. busbars (1 bar/phase) with W y 80 mm 50/60 mm 04636
horizontal bars
W > 80 mm 50/60 mm 04636 + 04642
W y 80 mm 80 mm 04637
W > 80 mm 80 mm 04637 + 04642
Connection vert. busbars (2 bars/phase) with W y 80 mm 50/80 mm 04637
horizontal bars
W > 80 mm 50/80 mm 04637 + 04642
Direct connection (115 mm centre distance)
The connection between horizontal busbars, 10 mm thick, and lateral flat busbar is
direct, after drilling the bars.
Drilling diagram for horizontal busbars, 10 mm thick.
Direct connection (75 mm centre distance)
For busbars with 75 mm between centres, the bars must fully overlap.
Drilling diagram for horizontal busbars, 10 mm thick.
Number of assembly screws no. 04645
Horizontal bars (mm) Vertical bars (mm)
50 60 80 100
50 2 2 2 2
60 - 2 2 2
80 - - 3 3
In case of direct connection (75 or 115 mm centre distance) with a horizontal
busbars, bottom support part no. NSYAS500, NSYAS800 or NSYAS800L are not
required.
version: 1.0 - 06/2010
5