Prisma Plus PH System - Schneider Electric

DD384396
DD384397
DD384398
Distribution
Catalogue numbers
The bars are secured by insulated supports attached to
the framework.
The tables opposite indicate:
b the number and size of the bars to be used,
depending on the permissible current level in the
busbars
b the number of busbar supports for each type of
framework, depending on:
v the size of the busbars
v the rated short-time withstand current Icw.
For more information on busbar calculations, see
DESW016.
The modularity of the busbar is 3 modules.
Fixed support and free support.
Joints.
NYBSHS500
DD381226
Horizontal busbars
Up to 1600 A
Flat copper bars 5 mm thick
Busbar calculation
Number and size of copper busbars
Permissible current (A) No. of bars/phase
IP55
750 1 bar 60 x 5
900 1 bar 80 x 5
1250 2 bars 60 x 5
1600 2 bars 80 x 5
Note: the permissible current values for the busbars are given for an ambient temperature of
35 °C around the switchboard.
Number of supports
Framework width Size of bars (mm) No. of supports lcw (kA rms/1 s)
(mm)
y 15 y 25 y 30 y 40 y 50
W 700 mm 1 bar 60 x 5
1 bar 80 x 5
2 bars 60 x 5
2 bars 80 x 5
2 3
W 300 mm All sizes 1 2
Busbar selection
Flat busbars, W 2000 mm
Designation Cat. no.
Copper bar without holes, 60 x 5 04536
Copper bar without holes, 80 x 5 04538
Busbar supports
Two fixed supports for 700 mm wide frameworks and one fixed support for 300 mm
wide frameworks are mandatory. If more supports are required, use free supports.
Designation Cubicle W 700 Cubicle W 300
D 500 D 500 D 800
Distance between busbar centres 75 75 75
Fixed support for horizontal bars 04664 NSYBHS500 NSYBHS800
Free support (additional) 04662 04662 04662
04664 04662
Joints
Designation Cat. no.
1 joint for bars W 60 mm 04640
W 80 mm 04641
Note: when installed at the bottom of cubicles, the busbars must be partitioned, see
page 401F22905.indd/2.
401F_E22110.indd version: 1.0 - 06/2010
1
DD381225