Structural Shapes - Nucor-Yamato Steel

Recommendations

Info

Nucor-Yamato Steel CZ13 Tolerances Dimensional Tolerance: Depth, inches A Over 0.063 Under 0.063 May 2013 Inside Width Long Flange, inches D Over 0 Under 0.125 Overall Width Short Flange, inches E Over 0.156 Under 0.250 Weight (%) Over 2.5 Under 2.5 Off-Squareness, Flange to Web Long Flange, inches H Up to 0.125 Short Flange J Over 1 o Under 1 o
Nucor-Yamato Steel Camber Tolerance: Camber denotes the curvature from the plane of either flange in the length of the section. If section is cambered, the camber of the long flange must be high at the center of length, and within limits specified below. Lengths Maximum, inches * Up to 41 foot inclusive 1.25 Over 41 foot to 51 foot inclusive 1.50 Over 51 foot to 66 foot inclusive 2.00 Over 66 foot to 82 foot inclusive 3.00 * Positive camber in overall straightness refers to when the outer face of the long flange is convex over the length of the center sill zee. Sweep Tolerance: Sweep denotes the curvature from the plane of the web in the length of the section. Maximum sweep in either direction = 0.125 inches X number of feet of total length 5 May 2013
Page 1 and 2:
Structural Shapes May 2013 May 2013
Page 3 and 4:
General Data contained within this
Page 5 and 6: Symbols A Cross sectional area, squ
Page 7 and 8: Available grades: ASTM: ASTM A 36/A
Page 9 and 10: Nucor-Yamato Steel A6 Section Size
Page 11 and 12: Nucor-Yamato Steel Prime Section Gr
Page 43 and 44: Nucor-Yamato Steel H - PILING DEALE
Page 53 and 54: Nucor-Yamato Steel Section 3 PS 27.
Page 55: Nucor-Yamato Steel CZ Special Car B
show all

Structural Shapes - Nucor-Yamato Steel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?