Instruction Handbook - TA Triumph-Adler
Instruction Handbook - TA Triumph-Adler Instruction Handbook - TA Triumph-Adler
General Information This chapter describes basic maintenance tasks you can perform for the printer. You can replace the toner container according to the printer's status: Also, the internal parts need periodic cleaning. Toner Container Replacement The Toner indicator identifies the toner status at two stages of toner usage. • When the printer becomes low on toner, the Toner indicator flashes. Note the replacement is not always necessary at this stage. • If you ignore the above status and continue printing, the Toner indicator lights up just before the toner is used up. The toner container must then be replaced immediately. In either case, replace the toner container. Frequency of toner container replacement Assuming an average toner coverage of 5% and EcoPrint mode turned off, the toner container will need replacing approximately once every 7,200 pages (LP 4135) or 2,500 pages (LP 4130). Starter Toner Container The toner container packed with the new printer is a starter toner container. The starter toner container lasts an average of 2,300 pages (LP 4135) or 1,000 pages (LP 4130). Toner Kits Note Information Collection on Memory Chips - The memory chip attached to the toner container is designed to improve convenience for the end user; to support the recycling operation of empty toner containers; and to gather information to support new product planning and development. The information gathered is anonymous - it cannot be associated to any specific individual and the data is intended to be used anonymously. For best results, we recommend that you only use genuine TA Triumph-Adler Parts and Supplies. A new toner kit contains the following items: • Toner Container • Plastic waste bag for old toner container • Installation Guide Note Do not remove the toner container from the carton until you are ready to install it in the printer. 4-2 Maintenance
Replacing the Toner Container This section explains how to replace the toner container. CAUTION Do not attempt to incinerate the Toner Container. Dangerous sparks may cause burns. IMPORTANT During toner container replacement, temporarily move storage media and computer supplies (such as floppy disks) away from the toner container. This is to avoid damaging media by the magnetism of toner. IMPORTANT TA Triumph-Adler is not liable against any damages or problems arising from the use of toner containers other than those designated as original TA Triumph-Adler toner containers. For optimum performance, it is also recommended to use only the TA Triumph-Adler toner containers which are specifically intended for use in your country or region. If the toner container for another destinations is installed, the printer will stop printing. Note You do not have to turn printer power off before starting the replacement. Any data that may be processing in the printer will be deleted if you turn the printer power off. 1 Open the top cover. 2 Turn the lock lever to the unlock position. Push the lock lever to the position marked by the arrow and pull out the toner container. Note Put the old toner container in the plastic bag (supplied with the new toner kit) and discard it later according to the local code or regulations for waste disposal. Maintenance 4-3
- Page 14 and 15: xii Safety Instructions Regarding t
- Page 16 and 17: xiv 11-13/16" (300mm) Installation
- Page 18 and 19: xvi Precautions for Use Cautions wh
- Page 20 and 21: xviii About the Operation Guide Thi
- Page 23 and 24: 1 Machine Parts This chapter identi
- Page 25 and 26: 10 11 12 13 Components at the Rear
- Page 27 and 28: Indicators Indicator Status Meaning
- Page 29 and 30: 2 Loading Paper This chapter explai
- Page 31 and 32: Paper cassette 356mm (14 inches) 14
- Page 33 and 34: Basis weight Basis weight is the we
- Page 35 and 36: Special Paper The following types o
- Page 37 and 38: Thick Paper Fan the stack of paper
- Page 39 and 40: Preparing the Paper After removing
- Page 41 and 42: Note Do not load paper above the tr
- Page 43 and 44: 1 2 Correct Incorrect Correct Corre
- Page 45 and 46: 3 Connecting and Printing This chap
- Page 47 and 48: Installing the Printer Driver Ensur
- Page 49 and 50: Custom Mode Use Custom Mode if you
- Page 51 and 52: 9 Click the plus symbol (+) to add
- Page 53 and 54: Printing This section explains the
- Page 55 and 56: Screen Overview The screen overview
- Page 57 and 58: Appearance Tab The Appearance tab i
- Page 59 and 60: Status Tab The Status tab displays
- Page 61 and 62: Others Tab The Others tab enables y
- Page 63: 4 Maintenance This chapter explains
- Page 67 and 68: 6 Turn the lock lever to the lock p
- Page 69 and 70: 4 Place the drum unit flat on a cle
- Page 71 and 72: Prolonged Non-Use and Moving of the
- Page 73 and 74: 5 Troubleshooting This chapter expl
- Page 75 and 76: Print Quality Problems Printed Resu
- Page 77 and 78: Understanding Indicators The indica
- Page 79 and 80: Indicator Meaning [Ready] indicator
- Page 81 and 82: Indicator Meaning Remedy A paper ja
- Page 83 and 84: Cleaning Paper Jams If paper jams i
- Page 85 and 86: Paper Cassette/Paper Feeder 1 Pull
- Page 87 and 88: Inside the Printer 1 Pull the paper
- Page 89 and 90: Rear Cover 1 Open the rear cover an
- Page 91 and 92: 6 Option This chapter explains the
- Page 93 and 94: Expansion Memory Modules To expand
- Page 95 and 96: 7 The memory module is secured to t
- Page 97 and 98: Network Interface Card The network
- Page 99 and 100: 4 Insert the CF Card. 5 Secure it w
- Page 101 and 102: 7 Appendix This section lists the f
- Page 103 and 104: Item Operating Environment Temperat
- Page 105 and 106: Index A Adhesive label ............
- Page 107 and 108: Toner indicator operation panel ...
- Page 110: UTAX GmbH, Ohechaussee 235, 22848 N
General Information<br />
This chapter describes basic maintenance tasks you can perform for the<br />
printer. You can replace the toner container according to the printer's<br />
status:<br />
Also, the internal parts need periodic cleaning.<br />
Toner Container Replacement<br />
The Toner indicator identifies the toner status at two stages of toner<br />
usage.<br />
• When the printer becomes low on toner, the Toner indicator flashes.<br />
Note the replacement is not always necessary at this stage.<br />
• If you ignore the above status and continue printing, the Toner<br />
indicator lights up just before the toner is used up. The toner<br />
container must then be replaced immediately.<br />
In either case, replace the toner container.<br />
Frequency of toner container replacement<br />
Assuming an average toner coverage of 5% and EcoPrint mode turned<br />
off, the toner container will need replacing approximately once every<br />
7,200 pages (LP 4135) or 2,500 pages (LP 4130).<br />
Starter Toner Container<br />
The toner container packed with the new printer is a starter toner<br />
container. The starter toner container lasts an average of 2,300 pages<br />
(LP 4135) or 1,000 pages (LP 4130).<br />
Toner Kits<br />
Note Information Collection on Memory Chips - The memory chip<br />
attached to the toner container is designed to improve<br />
convenience for the end user; to support the recycling operation of<br />
empty toner containers; and to gather information to support new<br />
product planning and development. The information gathered is<br />
anonymous - it cannot be associated to any specific individual and<br />
the data is intended to be used anonymously.<br />
For best results, we recommend that you only use genuine <strong>TA</strong> <strong>Triumph</strong>-<strong>Adler</strong><br />
Parts and Supplies.<br />
A new toner kit contains the following items:<br />
• Toner Container<br />
• Plastic waste bag for old toner container<br />
• Installation Guide<br />
Note Do not remove the toner container from the carton until you<br />
are ready to install it in the printer.<br />
4-2 Maintenance