Manuel d'utilisation - MTR

GB
USE OF THE HAND CONTROL
How to modify programs PROGRAM MODE:
Beginning
To switch off the unit
To press the two keys at
the same time to switch
the unit on
Then
To change the program if
necessary
To choose the movement
Or
Or
Or
Or
To display the lower limit
of the movement
To change the lower limit
of the movement if
necessary
To validate the new value,
press another key
Or display pauses
To change pause value in
upper limit of movement if
necessary
Keys to
press
or
Page 14
Display Remarks
Check if the locking switch
is in the following
position:
Welcome text during 3
seconds.
The program number
blinks.
The new program number
blinks.
The display indicates the
selected movement,
the program number
blinks again.
The display shows “not available”
if you d’ont have the horizontal
abduction module.
The value blinks.
or The new value blinks.
or
KINETEC
CENTURA V3.2
PROGRAM 1
EMPTY
PROGRAM 10
EMPTY
PROGRAM 10
30 ABD/ADD 90
PROGRAM 10
0 ROTATION 60
PROGRAM 10
30 FLEX/EXT 100
PROGRAM 10
30 SYNC ABD 100
PROGRAM 10
30 ABD HOR 100
PROGRAM 10
30 SYNC ABD 100
PROGRAM 10
50 SYNC ABD 100
PROGRAM 10
50 SYNC ABD 100
PROGRAM 10
TIMER 00H15
PROGRAM 10
SPEED : 1
PROGRAM 10
LOAD : _ _ _ _
PROGRAM 10
PAUSE HIGH 0
PROGRAM 10
PAUSE HIGH 10
The value blinks. Press
the or key
to change if necessary.
The pause value in upper
limit of movement blinks.
The new pause value in
upper limit of movement
blinks.