MAN-Combics Complete Scale CAW3P CAW3S CAH3-e - Sartorius

Operation
SQmin Operation
Configuration in Service Mode The SQmin value can only be entered in Service mode.
t Remove the cap.
t Slide the menu access switch to the left (= “open“ position).
If the device is part of a verified weighing facility, this will only be possible if the
verification seal is broken. The weighing equipment must then be verified again.
t Activate the Service mode, see “Service Mode.“
t In the “Device parameters“ menu, select “SQmin“ and open
using the “O“ soft key.
t Select “SQmin input“ using the “O“ soft key.
t Select “SQmin WP1“ using the “O“ soft key, enter the value via the keypad
(in this example 0.100 kg) and save using the “l“ soft key or cancel using “ESC.“
t Then enter the values for WP 2 and WP 3.
t Press M or “oo“ to exit the Setup menu.
t Slide the menu access switch to the right (= “closed“ position) and reattach the
cap.
y The device is now in normal weighing mode.
Configuration in Weighing Mode t In the “Device parameters“ menu, select “SQmin“ and open
using the “O“ soft key.
t Select “Display.“.
t Open using the “O“ soft key.
t Confirm the factory setting “oYes“ using the “l“ soft key.
t Press the “o“ soft key several times to switch to the next highest menu.
92 Operating Instructions Combics Complete Scales
The SQmin display must be turned on to use the SQmin function.
t In the “Fn key:SQmin display:“ menu, select using the “O“ soft
key and confirm using the “l“ soft key.
t Press M or “oo“ to exit the Setup menu.