MAN-Combics Complete Scale CAW3P CAW3S CAH3-e - Sartorius

Operating Design
Operating
Design
You can use the Combics 3 to
record weight values from 1 to
3 weighing platforms, calculate
and display weight values through
application programs, and assign
IDs to the samples weighed.
Configure the indicator first, using
the Setup menu for the desired
application program (printer
settings, etc.). Then you can begin
weighing.
When a key is pressed that does
not have an active operating mode
function, an acoustical signal
(double beep) sounds and the
message “——-—“ is displayed for
2 seconds. The display then
returns to the previous screen
content.
52 Operating Instructions Combics Complete Scales
Weighing Mode Operating Design
Labeled Keys
Some keys have a second function, activated by pressing and holding the key for
over 2 seconds. Whether a function is available depends on the indicator operating
state and operating menu settings.
e On/Off key
y standby is displayed in Standby mode.
n If a second weighing platforms is connected, this key toggles the display between
the two readouts.
( – Press briefly: Zero
– Press briefly: cancels calibration/adjustment
– Press longer than 2 seconds: displays the adjustment/configuration counter
) Tare the scale: press briefly.
k Displays the second weight unit or SQmin (depending on the settings, see
“Operation,“ “SQmin Function“).
J Starts calibration or adjustment.
p – For printing:
Press briefly.
– Prints GMP footer:
Press longer than 2 seconds.
K Toggles unit between normal and 10-fold higher resolution.
L Toggles the display between
gross value (net value plus tare) and
net value (gross value minus tare).
c – Quits an application or deletes an input character:
Press the key less than 2 seconds.
– Deletes the entire input string:
Press the key longer than 2 seconds.