MAN-Combics Complete Scale CAW3P CAW3S CAH3-e - Sartorius

Error Codes
Display Cause Solution
No display elements No power present Check power supply
------- Key has no function in this status
Flashing k Battery defective or time changed Set time
H Load exceeds weighing capacity Unload the scale
L or ERR 54 Weighing pan is not in place Position the weighing pan
ERR 101 - 104 Key is stuck Release key or
key pressed when switching on the device Contact your local Sartorius Service Center
ERR 320 Operating program memory faulty Contact your local Sartorius Service Center
ERR 335 Verified weighing platform not compatible Connect a compatible weighing platform
with the connected terminal
ERR 340 Incorrect operating parameter (EEPROM) Turn the scale off and then on again.
If the error code Err340 is still displayed
, please contact your local Sartorius Service Center
ERR 341 RAM has lost data Connect the device to power for at least 10 hours
Battery is empty
ERR 343 Loss of data in the memory area for transaction Contact your local Sartorius Service Center
numbers in external alibi memory
INF 01 “Display overload“ Data output not compatible with output format Set output format correctly
INF 02 “Zero point error Adjustment condition was not maintained, Unload the scale first then zero, then tare via the )
key at start of cal.“ e.g. not tared or weighing pan loaded
INF 03 Adjustment could not be completed Allow to warm up again and repeat the adjustment
within a certain time. process
INF 06 “Int. weight not
available or missing“
Built-in adjustment weight is defective Contact your local Sartorius Service Center
INF 07 “Function not allowed Function not allowed in scales verified for Contact your local Sartorius Service Center for
for verifiable weighing“ use in legal metrology information on changing settings
INF 08 The load on the scale is too heavy to zero Check whether “Tare/zero at power on” was complied
the readout with in your configuration.
INF 09 Taring is not possible when the scale gross
weight is < zero
Zero the scale
INF 10 Tare key is blocked when there is data in the The data stored for the application program must be .
tare memory deleted before taring
INF 22 Error in storing reference value Load is too light, place a heavier weight on the weigher
INF 23 “Application
initialization error“
Error in initializing an application Contact your local Sartorius Service Center
INF 29 “Scale minimum load Minimum load not reached Reduce minimum load (in the “Application parameters,”
not reached“ under “Minimum load for autom. initialization”)
INF 71 “Invalid value,“ Cannot store the current weight value None
Value too low/high“ or
“selection is not possible“
(e.g., control limits too low or too high)
INF 72 “Maximum quantity reached“ Cannot store the current weight value
(e.g. transaction counter maximum reached)
None
INF 73 “Memory deleted/
Memory not available“
Data not found or unreadable Contact your local Sartorius Service Center
INF 74 “Function is not available“ Function is blocked None
or
“Function is blocked“
(e.g. menu is blocked)
INF 88 “Function was started“ A function has been activated None
INF 98 No weighing platform connected Connect a weighing platform
INF 99 No weighing platform connected Connect a weighing platform
NO WP No weighing platform connected Connect a weighing platform
116 Operating Instructions Combics Complete Scales