Administration Manual - B.E.S.T. Undertaking.

4)
5)
6)
petrol, etc.
Not to carry out welding operations where oil spilled on the ground or in the vicinity where oil is stored in
open drums/tanks;
Not to keep the vehicles engines on when the petrol/diesel is being
decanted in the vehicle tanks or from the oil tanks to the underground
tanks;
Not try to set right the defects in the electric switches/switch boards
unless authorised to do so.
The Security Staff should enforce the above preventions strictly and report against the
defaulters.
Fire Control :
To
Extinguish
the fire :
the
When fire is noticed, the employees;
On
occurre
1)
2)
3)
nce of fire, the employees present on the premises should :
1)
2)
3)
4)
5)
6)
should not get panic;
should remove the combustible materials lying in the vicinity of fire;
should close the doors and windows and cut off the supply of air;
1051
switch off lights and fans preferably main switch should be switched off.
inform the S/Guard at the post in the vicinity immediately
decide as to what type of fire it is;
also decide whether the fire is likely to spread at speed and if so, inform
the Fire Brigade immediately;
proper Fire Extinguisher should be used to put off particular types of
fire;
In case of fire in the oil, only Foam Type Fire Extinguisher should be
used; SAT/Water Type Fire Extinguisher should not be used, as the fire
cannot be put off by Water Type Fire Extinguisher and it is likely that
the water jet from the extinguisher may disperse burning oil which may
set other combustible articles on fire and fire will spread around.;
If the fire is in the electric wiring or in the electric installation, main
switch should be immediately ‘switched off’ and DCP or CO2 type Fire
Extinguisher should be used. Use of any other type of Fire Extinguishers
containing water is likely to conduct electric current to the persons