Huron & SNAP Documentation

Placing the Observer
↓ To adjust the observers location
Adding speakers
↓ To add speakers to the array list
Placing speakers
↓ To place a speaker or edit its
location
Figure 28 – The Space Array Speakers dialog
THE SIMULATION TOOLS
The observer’s location represents the physical position of the
observers in the speaker array ie. the origin point for all the
speaker activations. By default the observer is located at 0,0,0
in the centre of the array, and the values given for the speakers
are given in terms of that origin point in metres.
1. Select the observer X field type new number.
2. Select the observer Y field and type a new number.
3. Select the observer Z field and type a new number.
1. On the array list click Add.
2. This will add a new speaker to the speaker list.
1. Select the X location.
2. Change the value.
3. Select the Y location.
4. Change the value.
5. Select the Z location.
6. Change the value.
HURON TECHNICAL MANUAL PAGE 84