Huron & SNAP Documentation

I/O Test Patching
Selecting the Format of Results
↓ To output to a log file
↓ To output a summary only to a
log file
↓ To output only to the I/O test
window
OTHER TOOLS
The I/O Test requires software patching via the Patch Bay as
well as physical patching on the Huron Patch Panel for it to
function properly. The Software and Hardware patching must
coincide with the modules to be tested.
The patching example given below shows how to test the Input
15 and Output 3 modules.
Figure 97 — The correct patching for IO Test
Once patched the I/O Tests may be run.
Each of the tests described below have a range of output
formats available. These outputs may be set through the output
selection boxes found below the signal section of the I/O test
window.
1. Select Log.
2. Click File.
3. From the Selection window enter a new file name or choose
a file to save the log information to.
4. Run the Test (see below).
1. Select Summary only.
2. Click File.
3. From the Selection window enter a new file name or choose
a file to save the Summary log information to.
4. Run the Test (see below).
1. Deselect Log.
2. Run the Test (see below).
The Test results will only appear in the display window.
HURON TECHNICAL MANUAL PAGE 286