Huron & SNAP Documentation

Muting
↓ To mute all output channels
↓ To unmute all output channels
Displaying Level Meters
↓ To display input level meters
↓ To display output level meters
Exiting VMixer
↓ To quit the VMixer
DSP Usage
2. Click the Ungroup button.
OTHER TOOLS
• Click on Mute. The mute button will be surrounded in red to
indicate that mute has been enabled.
• Click on Mute again.
VMixer includes level meters on each audio input and output
channel. Meter range is from –40dB to 0dB. By default,
channel labels are shown in place of channel meters.
• Click the input meter / label toggle button.
Input level meters will be displayed on the screen in place of the
input channel labels. Input level meters display the signal level
before the gain of the output level control is applied.
If the level meters are already displayed, clicking on the input
meter / label toggle button again will cause the input labels to
be displayed.
• Click the output meter / label toggle button.
Output level meters will be displayed on the screen in place of
the output channel labels. Output level meters display the
signal level after the gain of the input level control is applied.
If the level meters are already displayed, clicking on the output
meter / label toggle button again will cause the output labels
to be displayed.
Click the close control button on the menu bar of the VMixer
window.
The VMixer’s DSP resource usage is dependent on the number
of input and output channels that are available, as shown in the
table below:
HURON TECHNICAL MANUAL PAGE 277