Huron & SNAP Documentation

↓ To move a Slider
↓ To adjust a Sliders bandwidth
↓ To change the parametric
values for a slider
↓ To remove a Slider from a
canvass
THE EQUALISATION TOOLS
2. Clicking on the position in the canvass at which the slider
will be applied. A slider highlighted in red will appear at the
point clicked.
• Click and drag the Slider to its new location.
This moves the centre frequency at which the slider operates
and the cut/boost value to apply.
1. Double click on a Slider.
A red rectangle will appear around the selected Slider.
2. Click and Drag on the rectangle handles to Increase or
decrease the bandwidth over which the Slider will operate.
Figure 85 — An illustration of EQ bandwidth adjustment
The absolute value of frequency, cut/boost and bandwidth for
the active slider are displayed in the dialogue bar:
Figure 86 – Dialogue Bar parameters
1. Click on the Slider to be changed.
2. Type the values required into the dialogue bar.
The slider will move to its new position.
1. Click on the Slider to be deleted.
2. Then Either:
3. Select Delete from the Edit menu in the menu bar.
— or —
Press the delete key.
HURON TECHNICAL MANUAL PAGE 259