Huron & SNAP Documentation

↓ To generate a piecewise linear
signal
Figure 74 — The SigGen interface (impulse signal generation)
THE ENGINEERING TOOLS
2. Select the file type of the output file from the drop down
menu.
3. Select the data type of the output file from the drop down
menu.
4. Type the amplitude required in the Amplitude box.
5. Type the decibel amplitude required in the dB Amp box.
6. Type the length of the signal in the Length box.
7. Type a series of data points into the data points box. The
data points should be input as a series of X,Y pairs (For
example 128:1.0,150:0.8,...).
8. Type the number of vectors required into the Vectors box.
9. Select the sample rate of the output file from the drop down
menu.
10. Type a filename to output to, into the Output box.
— or —
Click Browse… and select a file name from the filename
dialogue box.
11. Click OK.
1. Select piece wise linear generation signal function type
from the drop down menu. This will display the following
dialogue box.
Figure 75 — The SigGen interface (Piece wise linear generation)
2. Select the file type of the output file from the drop down
menu.
3. Select the data type of the output file from the drop down
menu.
4. Type the amplitude required in the Amplitude box.
5. Type the decibel amplitude required in the dB Amp box.
HURON TECHNICAL MANUAL PAGE 229