Huron & SNAP Documentation

↓ To generate a noise signal
↓ To generate an impulse signal
THE ENGINEERING TOOLS
8. Type the phase of the signal into the Phase box.
9. Type the number of vectors required into the Vectors box.
10. Select the sample rate of the output file from the drop down
menu.
11. Type a filename to output the signal to, into the Output box.
— or —
Click Browse… and select a file name from the filename
dialogue box.
12. Click OK.
1. Select the Noise function type from the drop down menu.
This will display the following dialogue box.
Figure 73 — The SigGen interface (noise generation)
2. Select the file type of the output file from the drop down
menu.
3. Select the data type of the output file from the drop down
menu.
4. Type the amplitude required in the Amplitude box.
5. Type the decibel amplitude required in the dB Amp box.
6. Type the length of the signal in the Length box.
7. Type the random number seed into the Seed box.
8. Select the distribution Model of Noise from the Noise drop
down menu.
9. Type the number of vectors required into the Vectors box.
10. Select the sample rate of the output file from the drop down
menu.
11. Type a filename to output to, into the Output box.
— or —
Click Browse… and select a file name from the filename
dialogue box.
12. Click OK.
1. Select the impulse signal function type from the drop down
menu. This will display the following dialogue box.
HURON TECHNICAL MANUAL PAGE 228