Huron & SNAP Documentation

SigGen Windows Interface
↓ To start SigGen
↓ To generate a sine wave signal
Simwin — SigGen Tool
The SigGen function provides an interface for the generation of:
• Sine Wave signals.
• Noise signals.
• Impulse signals.
• Piecewise linear signals.
• Select Signal Generator on the Simwin function menu.
—or—
Click .
This will display the SigGen dialogue box. As different signal
functions are selected the dialogue box will change, allowing
the entry of function variables specific to that signal type. The
dialogue box shown below (Figure 72) is for the generation of
sine waves.
Figure 72 — The SigGen interface (sine wave generation)
1. Select the sine wave function type from the drop down
menu.
2. Select the file type of the output file from the drop down
menu.
3. Select the data type of the output file from the drop down
menu.
4. Type the amplitude required in the Amplitude box.
5. Type the decibel amplitude required in the dB Amp box.
6. Type the length of the signal in the Length box.
7. Type the frequency of the signal into the Frequency box.
HURON TECHNICAL MANUAL PAGE 227