Huron & SNAP Documentation

Selecting the Output File
↓ To select the name of the
Output File (excluding the file
extension)
Running the Measurement
↓ To run the measurement
Note: the measurement can take
several minutes to complete, the
bigger the Sum Multiplier and the
more inputs there are to be measured,
the longer the computation takes.
Level Metering
↓ To display level meters for all of
the inputs and outputs to the
Measurement tool
THE ENGINEERING TOOLS
The measurement of the IR of the system is written to a SIM
file. Each input response is saved to a file specified by the
Output File Field. The Response from the first input is written
to the file with a .001 extension, the second input is saved to a
file with a .002 extension, subsequent inputs follow this
sequential naming order.
1. Click Browse... on the Output File Field.
2. From the dialogue box, type or select the name of the file to
output to.
3. Click OK.
• Click Run.
The Run button will become disabled until the output signal has
been generated and an output file has been selected.
As each input’s response is calculated an estimate of the noise
floor is computed and displayed, this noise floor is used as a
measurement of confidence.
• Click Meters.
A level meter window will appear, each meter reflects the input
and output levels of a single signal.
HURON TECHNICAL MANUAL PAGE 200