Huron & SNAP Documentation

Note: All doors should have at least
one plane along which their width
equals zero (0.00).
Midi Commands
Convolver Commands
OTHER SIMULATION TOOLS
SetRoom R S
Assign an Acoustic Space S (Integer +ve) to a Room R (Integer
+ve).
SetRoomSegment R Xmin Ymin Zmin Xmax Ymax Zmax
Sets the Dimensions for a room segment (Float, XYZmin
specifies the lower left corner, XYZmax specifies the Upper
right corner) and associates the segment with Room R (Integer
+ve).
SetDoor D R1 R2 Xmin Ymin Zmin Xmax Ymax Zmax
Creates a Door D (Integer +ve) between Room 1 R1(Integer
+ve) and Room 2 R2 (Integer +ve), with the dimensions
specified by XYZ min (Floats, specifies the lower left corner
coordinates of the door) and XYZ max (Floats, specifies the
Upper right corner coordinates of the door).
OpenDoor D O
Open or Close Door D (Integer +ve) to the Value of Door
Closure O (Float between 0.00-1.00) where 0.00 is closed and
1.00 is open.
ResetMap
Clears the contents of the MultiScape Simulation Map. This
command must be issued prior to changing the size of room
segments in the map.
NoteOn M N V
MIDI NoteOn message on MIDI Channel M (Integer 1-16),
Note number N (Integer 1-128), Velocity V (Integer, 0-127).
(To turn off a MIDI note send a message on the same note
number with velocity 0).
ProgChange M P
MIDI Program change to program number P (Integer, 1-128) on
MIDI channel M (Integer, 1-16).
CtrlChange M C V
MIDI Controller change on MIDI channel M (Integer, 1-16), to
Controller C (Integer, 1-128), with the controller Value V
(Integer, 0-127).
ClvSetProgram N
Switch Convolver program number to N (Integer, 0 to number
of programs -1).
HURON TECHNICAL MANUAL PAGE 180